What steps need to go through between the completion of the equipment production and the customer receiving the equipment?
Today we will show you a series of operations after the Weld-Max welding and positioning equipment production is completed.
After each set of equipment is produced and installed according to customer requirements, our engineers will carry out the final commissioning of the equipment. The engineer connects the equipment to the power source and observes whether the equipment can operate normally and whether the various indexes are up to standard during the operation.
After commissioning, we will ensure that everything is normal before we proceed to the next step——packaging.
Before packaging, our employees will wipe clean the surface of the equipment and wrap the transparent film to prevent contamination or small scratches during transportation. Weld-Max will also “compress” the equipment to reasonably reduce the transportation space.
The bases of the welding rotators are stacked in groups. The welding manipulator is too tall to install the finished product, so the equipment column and boom will be disassembled after commissioning to save transportation costs.
According to the number of devices ordered by the customer, Weld-Max will need to choose whether wooden packaging.
When the order quantity is large, we will arrange the shipment of the entire container, and use the forklift to arrange the welding and positioning equipment in the container one by one and take protective and reinforcement measures.
When the quantity of equipment ordered is small, sea transportation needs to choose LCL, then our welding and positioning equipment needs to be packed in wooden boxes to ensure the safety of the welding and positioning equipment in the container.
When the wooden box is packed, small wooden strips will be reinforced at the base of the welding and positioning equipment to ensure that the equipment is stable in the wooden box and will not tip over.
Weld-Max packaging uses wooden boxes that meet export requirements. The wooden box made of solid wood is then treated with fumigation and anti-virus, usually refers to the fumigation treatment, or after heat treatment, and then covered with the IPPC seal, issued a formal fumigation certificate, so as to meet the export requirements of the wooden box.
The export packaging wooden boxes must meet the requirements of SN/T0273-93 “Inspection Regulations for the Transport Packaging Wooden Boxes of Export Commodities”. In the selection of materials, the main load-bearing components should be larch, masson pine, purple cloud pine, white pine, elm and other tree species with similar mechanical properties. The moisture content of the main load-bearing components should not exceed 25%, and the box boards and box stalls. The moisture content of wood is not more than 20%.
There shall be no more than 5 dead and live joints within 1000mm of the main stressed components and the box plate, and no defects such as decay, through cracks, sandwiching, worm eyes, mildew, blunt edges, etc. are allowed.
Workmanship: The seams of the box boards should be tight, the box board combination should be smooth and free of misalignment, the cloth nails should be reasonable, the reinforcement tape should be no less than two, the printing should be clear, the writing should be clear, and the commodity inspection code should be printed correctly.
Weld-Max always treats every customer attentively, and earnestly does every link to ensure that the equipment can safely reach the customer’s hands, and hopes that our products can improve customer production and satisfy customers.
Send your message to us:
Post time: Apr-07-2021